Step 1: All surfaces of the door must be lightly sanded with 180 grit sand paper. Care must be taken so as to avoid polishing any given area. Polishing of the wood will result in light spots when the stain is applied. If areas are left un-sanded, the opposite will occur and dark spots will appear.

Step 2: A stain controller or sealer can now be applied by brush or spray. Proceed immediately to the next step before sealer is dry. See local paint advisor for stain controllers available in your area.

Step 3: Stain the door with desired color by brushing, spraying or wiping with cloth. Stain must be applied evenly with a consistent amount of set time before wiping off. If left an inconsistent length of time, variation of color will occur. Allow stain to completely dry before proceeding to next step. See manufacturers specifications for dry time.

Step 4: Apply a light coat of sanding or lacquer sealer. Allow to dry (see manufacturers specifications for dry times).

Step 5: Lightly sand all surfaces with 220 grit to smooth out any bumps or fine fibers that the sealer may cause. Wipe all dust off of surfaces.

Step 6: Apply desired sheen of catalyzed lacquer topcoat. Avoid applying too much material at one time to avoid running or pooling of the material.

Step 7: Repeat steps 5 and 6 to desired amount of build depth.

Step 8: Dark colors are very susceptible to blotching. If color is uneven, a tinted lacquer will be required to even out the color. See paint dealer for compatibility of mixing 10-20% stain color to the lacquer. Once mixed, spray light spots to even out color. Apply a final clear topcoat to gain the desired build look.

Disclaimer: PINE DOORS ARE SOFTWOOD DOORS. DUE TO THE DIFFERENCES IN WOOD STRUCTURE, BLOTCHING IS VERY CHARACTERISTIC OF THIS WOOD TYPE. LIGHT STAIN COLORS ARE RECOMMENDED TO LESSEN THE DEGREE OF BLOTCHING. ALL WOOD IS A NATURAL PRODUCT AND THEREFORE IS UNIQUE. DO NOT EXPECT EACH DOOR TO LOOK ALIKE.